0
Owner's of the Sharp Home Theater System SHARP Sound Bar Home Theatre system gave it a score of 0 out of 5. Here's how the scores stacked up:
E-11
Remote control (continued)
Test of the remote control
Point the remote control directly at the remote sensor on
the sound bar.
The remote control can be used within the range
shown below:
15°15°
Remote sensor
0.2 m - 6 m
General control
Make sure to enable the HDMI CEC when making
HDMI connection. For details, refer to the operation
manual of the TV.
To turn the power on
Press the ON/STANDBY button on the sound bar or the
remote control.
The power turns on and the subwoofer indicator turns
blue. If the power does not turn on, check whether the
AC power lead is plugged in properly.
The system will automatically power on if TV or similar
component which supports HDMI CEC, is turned on.
To set the sound bar to standby mode:
Press the ON/STANDBY button again on the sound bar or
the remote control and the subwoofer indicator turns red.
Notes:
A slight audio delay after TV is turned ON does not
mean that the system is faulty. This is normal.
“AQUOS speaker is enabled” message will be
displayed if SHARP LCD TV does not detect HT-SB602
during power on. However the message “AQUOS
audio with AQUOS LINK is enabled” will be displayed
soon as HT-SB602 is detected. These messages may
vary for other TV model.
Standby mode
The fi rst time the unit is plugged in, it will enter the
STANDBY mode.
To cancel the STANDBY mode, press and hold the ECO
MODE button (remote control) during power standby
mode. The unit will enter the low power consumption
mode.
To return to the STANDBY mode, press the ECO MODE
button again.
During STANDBY condition, NFC function is activated
once your device touches the supplied NFC tag when
there is no HDMI connection.
Connecting the wireless Subwoofer
The sound bar and subwoofer will link automatically
(wirelessly) when turned on as it is already pre-linked at
the factory. If the link cannot be established, please set the
connection by the following method.
1. Press and hold the PAIRING button on the sound bar
or SW LINK on the remote control for more than 3
seconds.
2. Within 2 minutes, press and hold the SW LINK button
on the subwoofer for more than 3 seconds.
During pairing process:
On sound bar: “SW LINK” will blink.
On subwoofer: indicator will blink in blue.
When pairing is successful:
On sound bar: “SW LINK” disappears.
On subwoofer: indicator turns blue.
SW LINK
SW LINK
Subwoofer
Sound Bar
Remote
Control
Notes:
If a device such as microwave oven, wireless LAN card,
Bluetooth device or any other device that uses the
same 2.4GHz frequency near the system, some sound
interruption may be heard due to interference.
The transmission distance of the wireless signal between
the subwoofer and sound bar is about 10m (32 feet), but
may vary depending on your operating environment. If a
steel-concrete or metallic wall is between the subwoofer
and the sound bar, the system may not operate at all,
because the wireless signal cannot penetrate metal.
Caution:
Keep the subwoofer away from water and moisture.
To get the optimum listening performance, make sure
the area around the sound bar and subwoofer is clear
of any obstacles.
Find Your Products By Category
Please Login
