0

Out of 0 Ratings

Owner's of the Electrolux Oven Electrolux Wall Oven gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 44
 
30
Electronic Control Settings
USER PREFERENCES
(CONTINUED)
Changing between 12 or 24 hour time of day display:
1. Press USER PREF until you get to the CLO 12hr menu page.
2 Press
-
lo
or
+
hi
to toggle the display of the clock in 12 or 24 hours.
3. Press START to accept the changes and go back to user preferences menu display.
4. Remember to set your clock after changing the time of day display mode.
SETTING TIME OF DAY DISPLAY — 12 OR 24 HOURS:
The oven control can be programmed to display time of day in 12 hours or 24 hours
mode. The oven has been preset at the factory to display in 12 hours mode.
Changing clock display between ON and OFF:
1. Press USER PREF until you get to the CLO on menu page.
2. Press
-
lo
or
+
hi
to toggle between displaying or hiding the clock.
3. Press START
to accept the changes and go back to user preferences menu display.
SETTING CLOCK DISPLAY — ON OR OFF:
The oven control can be programmed to display the time of day or not. The oven has
been preset at the factory to display the time of day.
ADJUSTING OVEN TEMPERATURE:
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed. Each oven can be
individually adjusted.
To adjust the oven temperature:
1. Press USER PREFERENCES until you get to the UPO menu page.
2. Enter the temperature by pressing the
+
hi
or
-
lo
pads. The temperature can only be
adjusted by ± 35°F.
3. Press START to accept the changes and go back to user preferences menu display.